The purpose of this report is to collect, compile and complement the scientific and experience based knowledge concerning High pressure fire fighting today. The goal is to produce a decision data for the Rescue Service concerning the use of High pressure systems for fire fighting. Focus is on hose reel High pressure systems but other systems are discussed too. The report begins by describing the technical properties of the different systems. Then the fire fighting properties are evaluated, including manoeuvrability and safety for users.

Background: Pressure ulcers are a common problem and cause great suffering for those who develop it, and are also an expensive cost to the society. Aim: To describe nursing measures for prevention of pressure ulcers among elderly people in ordinary and nursing homes. Method: A literature review by structured analyze of scientific articles. Result: The analyze resulted in six subjects for prevention of pressure ulcers. These subjects were; risk assesment, nutrition, repositioning, skin/hygiene, nurse knowledge and documentation.

Prostate cancer is the most common cancer in men. One type of treatment is internal radiation therapy, brachytherapy. This treatment requires the patient to lie completely motionless and in lithotomy position. The purpose of this study was to investigate the prevalence of pressure ulcers associated with brachytherapy in prostate cancer at the UniversityHospitalin Uppsala. Furthermore, the purpose was to identify the most common location of pressure ulcer and to examine whether there were any connection between risk factors and possible pressure ulcers.

Compressed air is a low efficiency media, and is thus very expensive to produce. This thesis work began by mind mapping how to create savings on the compressed air system at Billerud Skärblacka AB. Certain issues have been chosen for further studies.In order to identify the consumption of compressed air at PM 8 and 9, several measurements were made. At PM 8 there were not found any pressure drop, only large pressure variations for short periods of time. The causes of these pressure variations were not established.

This thesis is seeking to explain why policy change come about. This is done by applying a part of Karin Lindgrens dissertation Vad styr ledaren?. The research evolves around the term pressure and the hypothesis are that policy change come about when there is middle range pressure on the decision-maker. Low and High pressure results in no or small policy change.The thesis is done as a case study where the economic crisis in Thailand 1996-1999 makes my case.

The running of gas turbines with low emissions causes High pressure pulsations to arise in the combustion chamber. These pulsations are high amplitude sound vibrations. At some frequencies these are harmful to the gas turbine. Hence these pulsations are monitored to avoid operating conditions where pulsations are specifically harmful. It is necessary to expose the system of known pulsations to verify the functionality of the monitoring process.

The objectives of this research were to determine whether the natural rattan resources in Sulawesi, Indonesia can cope with the strongly increased harvesting pressure that has occurred over the last centuries. I was furthermore looking for patterns in the rattan population dynamics that might give a hint on how the harvesting system could be improved to ensure a maximum sustainable yield. To answer these questions, I developed an individual-based model to analyse the dynamics of rattan growth in connection with rattan harvests by locals to identify sustainable levels of rattan harvests around villages in Sulawesi, Indonesia. Scenarios with different harvesting intensities were run to compare the change in harvest amount. For a given harvesting pressure, scenarios with a high number of harvesters and a low harvesting frequency had the same effect as scenarios with high harvesting frequencies and a low number of harvesters.

Sahlgrenska Academyat University of GothenburgDepartment of Internal Medicine and Clinical NutritionAbstractTitle: Does low fat dairy products reduce blood pressure?Author: Emma Bergman and Naman LimaniSupervisor: Lena HulthénExaminer: Anna WinkvistProgramme: Dietician study programme, 180/240 ECTSType of paper: Examination paper, 15 hpDate: May 26, 2014Background: It is estimated that at least a third of the population in Sweden have a high blood pressure with genetics, unhealthy diet and physical inactivity as the main contributing causes. High blood pressure is one of the greatest risk factors to develop cardiovascular diseases, which is the leading cause of death worldwide. Milk is a nutritional food product and previous research suggests that low fat dairy products may have blood pressure lowering effect.Objective: The aim was to examine the scientific basis of how low fat dairy products affect blood pressure.Search strategy: Twelve searches were conducted on PubMed and Scopus, where the chosen search terms were combined to produce a broad search as possible in the particular area. The search terms used were dairy, dairy products, milk, blood pressure and hypertension.Selection criteria: Studies on normotensive or hypertensive individuals who received low fat dairy products were included.

ABSTRACTPressure ulcers are a serious health damage that causes great suffering, prolonged hospital stays and increased health care costs. Patients undergoing surgery are at high risk of developing pressure ulcers and it is the operating theatre nurse responsibility to protect against health damage through nursing. There are little research made in the area of perioperative pressure ulcer prevention. In order to investigate perioperative pressure ulcer preventive care measures that are described in the litterature and to answer the question how the operating theater nurse can protect the patient, a pilot study of a systematic literature review was carried out. Data base searches were conducted in PubMed and Cinahl from where ten articles were selected and examined for their quality and content.

Sahlgrenska Academy at University of Gothenburg Department of Internal Medicine and Clinical NutritionAbstractTitle: Alpha-linolenic acid from flaxseed oil and effects on blood pressure ? A systematic reviewAuthor: Christine Hårdfelt och Liduina van SitterenSupervisor: Helen LindqvistExaminer: Anna WinkvistProgramme: Dietician study programme, 180/240 ECTSType of paper: Examination paper, 15 hpDate: April 9th, 2014Background: High blood pressure is strongly associated with an increased risk of developing cardiovascular disease, particularly stroke. ALA-fatty acids have previously been associated with decreased blood pressure. Flaxseed oil is very rich in these fatty acids and has also been highlighted as an affordable and sustainable source.Objective: To investigate whether ALA-fatty acids from flaxseed oil may affect blood pressure in people with high risk for cardiovascular disease.Search strategy: Two searches in PubMed and Scopus were performed. The sample was specified by using specific keywords.Selection criteria: The criteria for inclusion of studies required that flaxseed oil was compared with a control and that blood pressure was measured as an endpoint.

Heavy duty vehicles often have problems with traction during the winter periods. For vehicles that can lift tag axles it is possible to increase the normal force on the driven axle by lifting one or more tag axles, this will then increase the propulsive force of friction. This however increases wear on both road and vehicle. A possibility to reduce the wear while achieving nearly equivalent traction compared to lifted tag axles is to allow the vehicle to regulate the normal force by lowering the pressure in the air suspension associated with the tag axles or by the lifting of these axles. The vehicle would then by itself be able to set just the right amount of normal force on the drive wheels to avoid unnecessarily high normal forces while maintaining sufficient traction.The purpose of the report is to find out which parameters affect heavy duty vehicles when driving on slippery slopes and how traction can be improved.

The global climate-change means increasing mean-temperature and higher precipitation in Sweden, which leads to shorter periods of frozen ground in the forest. At the same time the harvesting machines are getting bigger and more powerful. The forest industry aim at an even wood flow, and the ground damage has to be as low as possible. The two biggest causes for ground-damage is the bearing capacity of the forest ground and the ground-pressure of the harvesting machines. The aim of this study was to find out some rules for the machine choice considering ground pressure, when harvesting on ground with low bearing capacity.A field study, using a Valmet 890.3 forwarder, was carried out where different ground pressures and their effect on the ground were tested on two different types of ground.Additionally, an inventory of damaged harvesting grounds was made.

AbstractIntroductionWedged shoe insoles are used as a treatment for different problems in order to change the ground reaction force. They can secondary cause different loading patterns under the foot compared to normal. No previous study has, to the author?s knowledge, clinically evaluated the plantar foot pressure with different full-length wedges in normal persons.PurposeThe purpose was to evaluate the plantar pressure with different degrees of full-length wedges in normal persons.MethodTwenty persons with normal feet have participated in this single blind study. Wedges were produced clinically in four different shapes, 3° valgus, 0° flat, 3° varus och 6° varus.

By our employer Camatec Industriteknik AB have we been given the assignment to continue with the previous work ?Design of strip feeder?. Our goal with this work is to come up with a design basis for a strip feeder.Functionally a strip feeder consists of two rollers which with the aid of the friction between the strip and the coating on the roller create a strip force that pulls the strip through the working progress.Demands on this project:? 10 ? 600 mm in strip width and 0,1-1 mm in strip thickness.? Minimum 30m/min in production speed.? A maximum strip force on 30-40 kN.? The cost of the strip feeder?s components is to be considered of economy and quality.The need of a strip feeder occurs when the coil doesn?t manage to feed or pull the strip before or after a working process. The strip can otherwise be exposed by a permanent yield deformation or a change in the strip material if it?s pulled trough the working process only by the on ? and of-coils.

The Homogeneous Charge Compression Ignition (HCCI) engine is promising in terms of lowNOx, low particulates and high efficiency. Due to its homogeneous charge, where thecombustion starts almost simultaneously from a number of points in the combustion chamber,only lean mixtures are possible to burn because of the resulting rapid combustion, which is muchfaster than the combustion in an SI-engine or a diesel engine. When richer mixtures are used thecombustion will start earlier and also be more violent.To phase the combustion later and lower the combustion speed, external cooled EGR can beused. The EGR-system used in this thesis uses a divided exhaust channel where one channel andits corresponding valve are used only for transporting EGR back to the intake system.Consequently the EGR-valve is connected to the intake pressure. This system is called Direct-EGR (D-EGR).Engine tests verified that the CA50 indeed is phased later when cooled EGR is used.